Kleim wallpaper, quickly and correctly

Wallpapers are at least two advantages over the painting - they can be used to make textured walls and decorate them with beautiful pictures. By mastering a few simple steps, you'll glue wallpaper like a pro!rain gutters |

Modern collections of wall covering styles and trends and offer a virtually unlimited range of decors, textures, textures and color combinations. Wallpapers are distinguished by water resistance (conventional, water-resistant, washable), density (light and heavy), mean surface (smooth, with a relief pattern, with shallow and deep relief pattern) and type of image (monochrome smooth, with small and large pattern).

Wallpaper with pattern. Determine the nature of the wallpaper patterns. The pattern can be symmetrical or asymmetrical about the axis of the canvas. This is important when calculating the required number of rolls. On the wallpaper with a pattern is the main element of the pattern that is repeated periodically along the length of the roll. The vertical distance between the repetitive elements is called a step pattern, or repeat. It ranges from 50 to 300 mm. The larger the repeat, the more thoroughly will remove the flag when fitting the neighboring edges. And the greater the waste.

Calculating the number of wallpapers

Measure the height of the walls from floor to ceiling and determine how much whole cloth obtained from each 10-meter roll. In case of doubt it is better to buy an extra roll. The label is usually specified digital code design wallpaper. Verify that all rolls have the same code, different shade of wallpaper may be different, that once bonded would be very noticeable.

Wallpapering - pleasant and burdensome task. Whole day of work - and the apartment clean and shine novelty. This is the easiest and fastest way to change the face of the flat.

When Wallcovering with a large figure is usually more waste, but the result certainly will make you happy.

When buying wallpaper, make sure that all rolls have the same number of design. And take one more roll.

Preparing the wall surface

Wallpaper paste for plastering the surface of walls or plasterboard. Never stick a new wallpaper over the old ones. Painted surfaces sufficiently cleaned. Porous surface or unpainted plaster necessarily treat the wallpaper adhesive, prepared according to manufacturer's instructions. Without such processing cloth wallpaper difficult to move along the wall with the matching pattern. Before hanging wallpaper glue on the wall to dry.

Room Layout

Start taping from the corner - it helps to hide the defects of a pattern in the wrong combination of cloth, glued the first and last. If the room has a fireplace, arch or other prominent architectural form and pattern on the wallpaper rather large, the first panel to be pasted so that his picture was placed on the axis of this architectural element. The other piece of cloth glued on both sides of the first. Determined the starting point, use a roll of wallpaper as a template for marking on the wall of cloth. If you find that any of the joints have an awkward place (for example, near the outside corner), then move the starting point, respectively.

Preparation wrapping

If you previously did not have to engage in such work, select wallpaper with arbitrarily aligns the figure, so you can focus directly on the technique of gluing, not being distracted by the combination. By the way, wallpaper with ready gummed stick is much easier. Before you begin, determine the direction of the pattern. Manufacturers ask him to roll the arrow that always points to the ceiling.

The choice of adhesive

The most important thing when choosing adhesives - to determine whether the glue is needed with the addition of fungicide. This adhesive is required when gluing waterproof materials (washable, vinyl wallpaper), because it prevents mold. Glue type indicated on the label. Ibid states for a number of rolls calculated contents of the package. Slowly pour the contents of the package in the required amount of water, stirring constantly to avoid lumps. Allow glue to settle and thicken during the time specified by the manufacturer. Clay keeps the quality of their work for about a week.

Cut the wallpaper with a pattern

Measure the height of the wall and add to each end of 100-150 mm in the fit. Expand and Mark the roll of cloth. Allowance can be made smaller, but then the counting should be more careful. If the mounting table on which you work is of sufficient size, it can be used as a template. First, we cut off the first panel with minimal oversize 50 mm. Figure the second fabric must combine with the first pattern: note on the cover of the length of the table cloths and the position of the pattern for the odd and even cloth.

Adhesive

The cloth is spread on the floor of the figure down. Glue is applied to the middle of the cloth, and then smeared with a brush in hand. Tschatelnno promazhte glue edges of cloth along the entire length. Glue does get to the floor when greasing the edge of cloth, just wipe with a damp cloth. Fold the edge of the flag plastered with adhesive inside. This will prevent it from drying out and will facilitate transportation to the wall. If a wallpaper made out of thick paper, take some time to absorb the glue. Therefore smeared glue panel temporarily aside and loans should be.

Wallpapers gummed

To label such wallpaper you need plastic trough, which is placed a roll of wallpaper. Fill it with cold water and place near the wall. Cut the cloth desired length, taking into account allowances and turn in the roll face up and the upper end of the outside. Immerse the roll in the trough at the desired time. Hand on the top edge of the roll, drag it over the wall up toward the ceiling. The excess water will flow into the trough. Wing, smooth and cut wallpaper.

Glueing and fitting wallpaper

The first sheet should stick with a plumb. The corners of the room is never strictly vertical, so use them to align the first piece of cloth can not. Incorrect label first paintings leads to serious defects in the arrangement of the picture. Using a plumb apply to the wall a vertical line at a distance from the angle of approximately 25 mm less than the width of cloth. To get to the ceiling, you will need the ladder, chair or table. Advance approaches to clear a wall, because the glue dries quickly, and work is desirable, too quickly. Take the prepared panel to the wall and bend the upper plastered with adhesive edge. Slide the panel upward slightly, to about 50 mm in length was setting up at the ceiling, and align the edge with a vertical mark on the wall. In this part of the fabric zavernetsya and lies adjacent to the wall, closing the angle. Smooth wallpaper with a soft cloth or brush in the direction from the center outwards. Then expand the lower part of the baking dish with adhesive and smooth out, too. Carefully align the wallpaper, bent in the corner.

Step 1

Carefully promazhte fabric glue, paying particular attention to the edges, and let it soak.

Step 2

Add the baking dish, wallpaper glue part by placing glue on the glue. This will prevent it drying out.

Step 3

Cross-sections can be done with the help of a guide and universal knife.

Step 4

Hold a plumb line to the wall and Draw a vertical line. Spend it on the entire length.

Step 5

Carefully expand the canvas, carefully align it on the marked line and glue.

Step 6

Using a brush or roller, smooth the fabric and throw him out of the air.

Step 7

Using scissors or a pencil Draw the cutting line on the ceiling and wall moldings.

Step 8

Few pull the cloth and just cut it to the planned lines.

Step 9

Fabrics in the inner corners to go with the overlap in 2-2,5 cm

Step 10

Window openings and niches okleivayutsya so that the paintings were located overlapped. The edges are cut off.

Step 11

When treating the doorway first try on the dry cloth, and then Cleito.

Step 12

Pasted wallpaper switches to open the two cuts on the diagonal, the remnants of paper to remove.

Tools for making glue and Wallpapering.

The flip side of scissors held between the ceiling and the wall, outlining the wallpaper of the cut line. Separate wallpaper from the wall and cut on the intended line. Apply wallpaper on the place and smooth out. Likewise, prune wallpaper from plinth. Smear and assigned to the next wall panel. Bend the top, push the wall and align the image with a pattern on the first panel. Smooth and trim panel, as indicated above. Then glue a sheet of cloth. Begin to glue on the window, moving deep into the room - the joints will be less noticeable. The cloth should go a little on the ceiling and baseboard. If you just place the sticker sheet as evenly as possible. Normally right-handed convenient to work, moving clockwise, Lefty-counterclockwise.

Remove air bubbles

Sometimes it happens that the wallpaper does not stick, and form bubbles on the wall. Deal with this problem you anoint a simple syringe.

How would carefully you may work from time to time still form bubbles. If the bubble is large and in the middle of the cloth to smooth it fails. In this case, firstly, it pierced to allow air to go. Then type in a little glue and a syringe with a needle fill it with wallpaper. It remains to smooth the surface of the canvas.