Wall cladding panels

Framed panels are slightly different from tongued, but they both have the same decorative effect. Previously framed panels fabricated joiners. Today is sold ready-made kits that enable DIY independently perform this work. The kit includes all the necessary details, and work, in fact, is ready to fix the panel on the wall in the correct sequence. This avoids the frame attached to the wall of wooden slats.Kleiner Stab, grosse Wirkung. Holzdildos aus Kiefer. |

Using ready-made sets of panels - a fast and effective way of finishing the walls. These panels look as if they are made the traditional way. They are best to strengthen the glue, not nails.www.prepaid-internet.eu |

Framed panels can be located on one level, but they can be used for cladding the stair wells. Relevance finish decorating the room of other elements, such as doors, drawing the panels together with the interior room.

Step 1

Before sewing the final panel of the wall, it is necessary to dismantle the old skirting boards. New skirting boards should be cut to desired length and attach to the wall is not nailed, but with the help of glue. The panels are inserted into the slot in the baseboard.

Step 2

Attach the new skirting boards, pressed them to the wall. Since the floor is not always smooth, check the levelness top plinth using a spirit level. If necessary, lightly trim skirting boards so that their upper sides are on the same level throughout the length of the walls.

Step 3

To attach the panel to the wall apply glue to those of their surface, which will be in direct contact with the wall.

Step 4

Insert the panel into the slot in the upper edge of the baseboard and push it to the wall. If the skirting was installed correctly, the panel will also be installed correctly.

Step 5

In most of these kits are used to connect the panels strips, installed between the panels. Apply glue to the reverse side of the strip and glue it next to a previous panel. Planck fits with her groove and tongue.

Step 6

Attach to the wall all the panels and strips, cut off the last panel, so that they snugly into the corners of the room. To connect a "mustache" Dado rails in the corners of the room trim the ends at an angle of 45 °.

Step 7

Brush glue the back side of the slats Dado and attach it along the upper edge of the panels. After the glue grab, close all the gaps between panels. Then the panel can be finished to suit your taste.

Tips

In order not to saw the panel on the parts, which can spoil the appearance, define the place where we will start lining. If it starts with each side of the door, it looks symmetrical and neat.

Try to make the junction at the bottom of a flight of stairs. Then the panel can be arranged so as to enhance the effect of "step".

Try to make the ugly "trimming" located in less visible places, or hiding room furniture.