Wall panels

Panels from the wallpaper - an alternative and very attractive decoration wall decoration. Engineering work is simple, but you must carefully plan how to use a particular pattern on the wallpaper to achieve a harmonious effect. In addition, it is necessary to ascertain all sizes. It is also important to choose a frame panel curb harmony with the pattern on it.affordable life insurance |

Some manufacturers produce borders, combined with certain types of wallpaper, so not all are suitable for framing panels. Border, walking along the perimeter of the panel, the corners need to connect "in the mustache, cropped appropriately. Therefore, drawing himself curb shall meet this requirement. Curbs with a funky geometric pattern is often not suitable for this purpose, as the incision through the picture at an angle of 45 °, required for the connection "in the CSS, can lead to inconsistencies figure.

Choose a curb with a "streamlined" pattern, which can be cut to connect "in the mustache" so as to obtain a good docking strips in the corners. To frame the panels will work well to curb a "living" floral pattern, a slight discrepancy which would be almost invisible. If you plan to do is not very small panel, for their creation need dock at least two pieces of wallpaper. Before gluing the panels accurately align the pattern and cut wallpaper to the desired length.

The panels of wallpaper - a striking decorative wall finishing, especially on the perimeter of the panel is curb. In this work must be precise combination of pattern wallpaper and correct technique of glueing.

Dimensions of panels should be in harmony with the open parts of the walls. Choose wallpaper and borders with patterns suitable for the establishment of panels in the corners because the curbs have to dock at an angle of 45 °.

The panel can serve as an independent element of the decoration and backdrop for pictures and mirrors.

Step 1

Cut the strip along the wall, slightly larger than the height of the panel, and put them by aligning the edges on the table. Take a piece of the curb as a guide for the size of the panel, then on top of the strips with a pencil mark the wall with a ruler the size of the panel.

Step 2

In order not to scratch the table, put one of the bands on the wall board. With a knife, trim the strip with a ruler along the pencil line. Do the same with the other strips of wallpaper.

Step 3

Using a spirit level and ruler, apply to the wall line, marking the position of the lower edge of the panel. If the wall is a few panels, apply a similar line on the wall for each panel.

Step 4

Brush the glue strips of wallpaper paste them on the wall and smooth the brush. The lower edge of the bands should just be combined with a drive line, and they should just butt-joined. Let the wallpaper to dry.

Step 5

Once the panel is dry, glue the front page of curb along its upper edge. Use the top edge of the panel as a guide to the top of the curb. The band must curb a little go on the wall on both sides.

Step 6

Glue the first vertical strip over the top horizontal border strip, just combining the picture in place of the joint bands. Attach to the seam line at an angle of 45 ° from corner to corner and Cut with a knife, overlapping bands curb.

Step 7

Pulling up, gently separate the two pieces of curb and wipe off excess glue. You get a connection curb "in the mustache." Discard the trim and smooth the border strip on the wall wallpaper brush.

Step 8

Erase all the excess glue from the surface of the curb with a clean damp sponge. Glue the remaining border strip, consecutively treating the corners, as indicated above.